PIC16F946-ESLASHMLQTP datasheet(217/330 Pages) MICROCHIP

217 / 330 page

DS41250F-page 215

PIC16F913/914/916/917/946

15.3

PWM Mode

The PWM mode generates a Pulse-Width Modulated

signal on the CCPx pin. The duty cycle, period and

resolution are determined by the following registers:

•PR2

•T2CON

• CCPRxL

• CCPxCON

In Pulse-Width Modulation (PWM) mode, the CCP

module produces up to a 10-bit resolution PWM output

on the CCPx pin. Since the CCPx pin is multiplexed

with the PORT data latch, the TRIS for that pin must be

cleared to enable the CCPx pin output driver.

Figure 15-3 shows a simplified block diagram of PWM

operation.

Figure 15-4 shows a typical waveform of the PWM

signal.

For a step-by-step procedure on how to set up the CCP

module for PWM operation, see Section 15.3.7

“Setup for PWM Operation”.

FIGURE 15-3:

SIMPLIFIED PWM BLOCK

DIAGRAM

The PWM output (Figure 15-2) has a time base

(period) and a time that the output stays high (duty

cycle).

FIGURE 15-4:

CCP PWM OUTPUT

Note:

Clearing the CCPxCON register will

relinquish CCPx control of the CCPx pin.

CCPRxL

CCPRxH(2) (Slave)

Comparator

TMR2

PR2

(1)

Duty Cycle Registers

CCPxCON<5:4>

Clear Timer2,

toggle CCPx pin and

latch duty cycle

Note 1:

The 8-bit timer TMR2 register is concatenated

with the 2-bit internal system clock (FOSC), or

2 bits of the prescaler, to create the 10-bit time

base.

In PWM mode, CCPRxH is a read-only register.

TRIS

CCPx

Comparator

Period

Pulse Width

TMR2 = 0

TMR2 = CCPRxL:CCPxCON<5:4>

TMR2 = PR2

PIC16F946-E/MLQTP 데이터시트(PDF) 217 Page - Microchip Technology

PIC16F946-E/MLQTP 데이터시트(HTML) 217 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL