L9679P datasheet(207/279 Pages) STMICROELECTRONICS

207 / 279 page

DS11627 Rev 7

207/279

L9679P

Safing logic

278

A specific waveform needs to be present on ACL input in order to instruct L9679P to arm all

deployment loops. L9679P is designed to support the Additional Communication Line (ACL)

aspect of the ISO-26021 standard, which requires an independent hardwired signal (ACL) to

implement the scrapping feature. The disposal signal may come from either the vehicle's

service connector, or the systems main microcontroller, depending on the end customer's

requirements.

The arming function monitors the disposal PWM input (ACL pin) for a command to arm all

loops for vehicle end-of-life. The disposal signal characteristic is shown in Figure 64. To

remain in Arming state, at least three cycles of the ACL signal must be qualified (in addition

to the periodic KEY value being received from the microcontroller). For the device to qualify

the periodic ACL signal, the period and duty cycle are checked. Two consecutive cycles of

invalid disposal signal are to be received to disqualify the ACL signal.

If the logic detects that the signal is incorrect or missing while in Scrap state, the device will

stay in Scrap state; would it happen in Arming state, it will transition to Scrap state

immediately.

Figure 64. Disposal PWM signal

The disposal PWM signal cycle time and on time parameters can be found in the electrical

parameters tables.

GAPGPS01149

Cycle time

On time

L9679P 데이터시트(PDF) 207 Page - STMicroelectronics