TDS 310, TDS 320 & TDS 350 Instruction Manual
67
Functional Test
The purpose of this procedure is to confirm that the oscilloscope functions
properly.
This procedure verifies functions; that is, it verifies that oscilloscope
features operate. It does not verify that they operate within limits.
Therefore, when the instructions that follow call for you to verify that a
signal appears onscreen that is about five divisions in amplitude" or
has a period of about six horizontal divisions," etc., do NOT interpret
the quantities given as limits. Operation within limits is checked in
Performance Tests, which begin on page 611.
DO NOT make changes to the front panel settings that are not called
out in the procedure. If you make changes to these settings other
than those called out in the procedure, you may obtain invalid results.
In this case, just redo the procedure from step 1.
NOTE
If the oscilloscope fails anyof these checks it has failed the perfor
mance verification. To diagnose the causes of a failure, proceed to
the troubleshooting procedures on page 827.
Equipment Required: One P6109B (TDS 310 and TDS 320) or P6111B
(TDS 350) probe (Item 9).
Time Required: Approximately 5 minutes.
Prerequisites: None.
Procedure:
1. Install the probe on CH 1. Connect the probe tip to PROBE COMP on
the front panel; leave the probe ground unconnected. (See Figure 63.)
Korean ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
