ST7FOXK2 datasheet(151/226 Pages) STMICROELECTRONICS

부품명	ST7FOXK2

상세설명	8-bit MCU with single voltage Flash memory, SPI, I²C, ADC, timers

PDF	226 Pages

Scroll/Zoom	100%

제조업체	STMICROELECTRONICS [STMicroelectronics]

홈페이지	http://www.st.com

Logo

151 / 226 page

ST7FOXF1, ST7FOXK1, ST7FOXK2

On-chip peripherals

151/226

Bit 1 = STOP Generation of a Stop condition bit

This bit is set and cleared by software. It is also cleared by hardware in master mode.

Note: This bit is not cleared when the interface is disabled (PE=0).

●

In master mode:

0: No stop generation

1: Stop generation after the current byte transfer or after the current Start condition is

sent. The STOP bit is cleared by hardware when the Stop condition is sent.

●

In slave mode:

0: No stop generation

1: Release the SCL and SDA lines after the current byte transfer (BTF=1). In this mode

the STOP bit has to be cleared by software.

Bit 0 = ITE Interrupt Enable bit

This bit is set and cleared by software and cleared by hardware when the interface is

disabled (PE=0).

0: Interrupts disabled

1: Interrupts enabled

Refer to Figure 72 for the relationship between the events and the interrupt.

SCL is held low when the ADD10, SB, BTF or ADSL flags or an EV6 event (See

Figure 71) is detected.

ST7FOXK2 데이터시트(PDF) 151 Page - STMicroelectronics