ST7FOXK2 datasheet(163/226 Pages) STMICROELECTRONICS

부품명	ST7FOXK2

상세설명	8-bit MCU with single voltage Flash memory, SPI, I²C, ADC, timers

PDF	226 Pages

Scroll/Zoom	100%

제조업체	STMICROELECTRONICS [STMicroelectronics]

홈페이지	http://www.st.com

Logo

163 / 226 page

ST7FOXF1, ST7FOXK1, ST7FOXK2

On-chip peripherals

163/226

The SPIF bit can be cleared during a second transmission; however, it must be cleared

before the second SPIF bit in order to prevent an Overrun condition (see Section : Overrun

condition (OVR)).

10.6.5

Clock phase and clock polarity

Four possible timing relationships may be chosen by software, using the CPOL and CPHA

bits (See Figure 77).

Note:

The idle state of SCK must correspond to the polarity selected in the SPICSR register (by

pulling up SCK if CPOL = 1 or pulling down SCK if CPOL = 0).

The combination of the CPOL clock polarity and CPHA (clock phase) bits selects the data

capture clock edge.

Figure 77 shows an SPI transfer with the four combinations of the CPHA and CPOL bits.

The diagram may be interpreted as a master or slave timing diagram where the SCK pin, the

MISO pin and the MOSI pin are directly connected between the master and the slave

device.

Note:

If CPOL is changed at the communication byte boundaries, the SPI must be disabled by

resetting the SPE bit.

ST7FOXK2 데이터시트(PDF) 163 Page - STMicroelectronics