ST90R158 datasheet(152/190 Pages) STMICROELECTRONICS

152 / 190 page

152/190

ST90158 - SERIAL COMMUNICATIONS INTERFACE (SCI)

SERIAL COMMUNICATIONS INTERFACE (Cont’d)

9.5.9 Interrupts and DMA

9.5.9.1 Interrupts

The SCI can generate interrupts as a result of sev-

eral conditions. Receiver interrupts include data

pending, receive errors (overrun, framing and par-

ity), as well as address or break pending. Trans-

mitter interrupts are software selectable for either

Transmit Buffer Register Empty (BSN set) or for

Transmit Shift Register Empty (BSN reset) condi-

tions.

Typical usage of the Interrupts generated by the

SCI peripheral are illustrated in Figure 85.

The SCI peripheral is able to generate interrupt re-

quests as a result of a number of events, several

of which share the same interrupt vector. It is

therefore necessary to poll S_ISR, the Interrupt

Status Register, in order to determine the active

trigger. These bits should be reset by the program-

mer during the Interrupt Service routine.

The four major levels of interrupt are encoded in

hardware to provide two bits of the interrupt vector

er vectors to be resolved to an 8 byte block size.

The SCI interrupts have an internal priority struc-

ture in order to resolve simultaneous events. Refer

also to Section 9.5.3 SCI Operating Modes for

more details relating to Synchronous mode.

Table 30. SCI Interrupt Internal Priority

Receive DMA Request

Highest Priority

Transmit DMA Request

Receive Interrupt

Transmit Interrupt

Lowest Priority

ST90R158 데이터시트(PDF) 152 Page - STMicroelectronics