| 전자부품 데이터시트 검색엔진 |
|
M30620ECFS 데이터시트(PDF) 377 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
M30620ECFS 데이터시트(HTML) 377 Page - Renesas Technology Corp |
|
377 / 621 page ![]() UART Mitsubishi microcomputers M16C / 62 Group SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER 362 In receiving data in UART mode, choose functions from those listed in Table 2.5.5. Operations of the circled items are described below. Figure 2.5.11 shows the operation timing, and Figures 2.5.12 and 2.5.13 show the set-up procedures. 2.5.3 Operation of Serial I/O (reception in UART mode) Table 2.5.5. Choosed functions Item Set-up Transfer clock source (Note 2) Internal clock (f1 / f8 / f32) External clock (CLKi pin) RTS function RTS function enabled RTS function disabled O O CTS / RTS separation function (Note 1) Pin shared by CTS and RTS CTS and RTS separate O Sleep mode (Note 2) Sleep mode off Sleep mode selected O Item Set-up Data logic select function (Note 3) No reverse Reverse O TXD, RXD I/O polarity reverse bit (Note 3) No reverse Reverse O Bus collision detection function (Note 3) O Not selected Selected _______ ________ Note 1: UART0 only. (UART1 CTS/RTS function cannot be used when this function is selected.) Note 2: UART0, UART1 only. Note 3: UART2 only. (1) Setting the receive enable bit to “1” readies data-receivable status. At this time, output from ________ the RTSi pin goes to “L” level to inform the transmission side that the receivable status is ready. (2) When the first bit (the start bit) of reception data is received from the RxDi pin, output from the _______ RTS goes to “H” level. Then, data is received, bit by bit, in sequence: LSB, ····, MSB, and stop bit(s). (3) When the stop bit(s) is (are) received, the content of the UARTi receive register is transmitted to the UARTi receive buffer register. At this time, the receive complete flag goes to “1” to indicate that the reception is completed, the _______ UARTi receive interrupt request bit goes to “1”, and output from the RTS pin goes to “L” level. (4) The receive complete flag goes to “0” when the lower-order byte of the UARTi buffer register is read. Operation |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |