M38048FDHKP datasheet(333/387 Pages) RENESAS

333 / 387 page

3-43

REJ09B0212-0100Z

Rev.1.00

Jan 14, 2005

3804 Group (Spec.H)

APPENDIX

3.4 Countermeasures against noise

Fig. 3.4.1 Wiring for the RESET pin

3.4 Countermeasures against noise

Countermeasures against noise are described below. The following countermeasures are effective against

noise in theory, however, it is necessary not only to take measures as follows but to evaluate before actual use.

3.4.1 Shortest wiring length

The wiring on a printed circuit board can function as an antenna which feeds noise into the microcomputer.

The shorter the total wiring length (by mm unit), the less the possibility of noise insertion into a microcomputer.

(1)

Wiring for RESET pin

Make the length of wiring which is connected to the RESET pin as short as possible. Especially,

connect a capacitor across the RESET pin and the VSS pin with the shortest possible wiring (within

20 mm).

q Reason

The width of a pulse input into the RESET pin is determined by the timing necessary conditions.

If noise having a shorter pulse width than the standard is input to the RESET pin, the reset is

released before the internal state of the microcomputer is completely initialized. This may cause

a program runaway.

RESET

Reset

circuit

Noise

VSS

Reset

circuit

VSS

RESET

VSS

N.G.

O.K.

M38048FDHKP 데이터시트(PDF) 333 Page - Renesas Technology Corp