AT89C5122DS-RDRUM datasheet(128/208 Pages) ATMEL

128 / 208 page

128

AT83R5122, AT8xC5122/23

4202F–SCR–07/2008

Figure 69.

Serial I/O Port Block Diagram (Mode 0)

Transmission (Mode 0)

To start a transmission mode 0, write to SCON register clearing bits SM0, SM1.

As shown in Figure 70, writing the byte to transmit to SBUF register starts the transmis-

sion. Hardware shifts the LSB (D0) onto the RXD pin during the first clock cycle

composed of a high level then low level signal on TXD. During the eighth clock cycle the

MSB (D7) is on the RXD pin. Then, hardware drives the RXD pin high and asserts TI to

indicate the end of the transmission.

Figure 70.

Transmission Waveforms (Mode 0)

Reception (Mode 0)

To start a reception in mode 0, write to SCON register clearing SM0, SM1 and RI bits

and setting the REN bit.

As shown in Figure 71, Clock is pulsed and the LSB (D0) is sampled on the RXD pin.

The D0 bit is then shifted into the shift register. After eight sampling, the MSB (D7) is

shifted into the shift register, and hardware asserts RI bit to indicate a completed recep-

tion. Software can then read the received byte from SBUF register.

Figure 71.

Reception Waveforms (Mode 0)

IBRG

CLOCK

TXD

RXD

SBUF Tx SR

SBUF Rx SR

SM1

SCON.6

SM0

SCON.7

Mode Decoder

M3 M2 M1 M0

Mode

Controller

SCON.0

SCON.1

CK_

Baud Rate

Controller

Write to SBUF

TXD

RXD

Write to SCON

TXD

RXD

Set REN, Clear RI

AT89C5122DS-RDRUM 데이터시트(PDF) 128 Page - ATMEL Corporation

AT89C5122DS-RDRUM 데이터시트(HTML) 128 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL