ATtiny167 datasheet(107/282 Pages) ATMEL

107 / 282 page

107

7728D–AVR–07/09

ATtiny87/ATtiny167

11. Timer/Counter1 Prescaler

11.1

Overview

Most bit references in this section are written in general form. A lower case “n” replaces the

Timer/Counter number.

11.1.1

Internal Clock Source

The Timer/Counter can be clocked directly by the system clock (by setting the CSn2:0 = 1).

This provides the fastest operation, with a maximum Timer/Counter clock frequency equal to

system clock frequency (fCLK_I/O). Alternatively, one of four taps from the prescaler can be

used as a clock source. The prescaled clock has a frequency of either fCLK_I/O/8, fCLK_I/O/64,

fCLK_I/O/256, or fCLK_I/O/1024.

11.1.2

Prescaler Reset

The prescaler is free running, i.e., operates independently of the Clock Select logic of the

Timer/Counter. Since the prescaler is not affected by the Timer/Counter’s clock select, the

state of the prescaler will have implications for situations where a prescaled clock is used. One

example of prescaling artifacts occurs when the timer is enabled and clocked by the prescaler

(6 > CSn2:0 > 1). The number of system clock cycles from when the timer is enabled to the

first count occurs can be from 1 to N+1 system clock cycles, where N equals the prescaler

divisor (8, 64, 256, or 1024).

It is possible to use the prescaler reset for synchronizing the Timer/Counter to program execu-

tion. However, care must be taken if the other Timer/Counter that shares the same prescaler

also uses prescaling. A prescaler reset will affect the prescaler period for all Timer/Counters it

is connected to.

11.1.3

External Clock Source

An external clock source applied to the T1 pin can be used as Timer/Counter clock (clkT1).

The T1 pin is sampled once every system clock cycle by the pin synchronization logic. The

synchronized (sampled) signal is then passed through the edge detector. Figure 11-1 shows a

functional equivalent block diagram of the T1 synchronization and edge detector logic. The

registers are clocked at the positive edge of the internal system clock (clk

I/O). The latch is

transparent in the high period of the internal system clock.

The edge detector generates one clkT1 pulse for each positive (CSn2:0 = 7) or negative

(CSn2:0 = 6) edge it detects.

Figure 11-1. T1 Pin Sampling

Tn_sync

(To Clock

Select Logic)

Edge Detector

Synchronization

clk

I/O

ATtiny167 데이터시트(PDF) 107 Page - ATMEL Corporation

ATtiny167 데이터시트(HTML) 107 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL