PIC12F1822-ISLASHMF datasheet(271/398 Pages) MICROCHIP

271 / 398 page

 2010 Microchip Technology Inc.

Preliminary

DS41413A-page 271

PIC12F/LF1822/16F/LF1823

24.6.13.3

Bus Collision During a Stop

Condition

Bus collision occurs during a Stop condition if:

After the SDA pin has been deasserted and

allowed to float high, SDA is sampled low after

the BRG has timed out.

After the SCL pin is deasserted, SCL is sampled

low before SDA goes high.

The Stop condition begins with SDA asserted low.

When SDA is sampled low, the SCL pin is allowed to

float. When the pin is sampled high (clock arbitration),

the Baud Rate Generator is loaded with SSP1ADD and

counts down to 0. After the BRG times out, SDA is

sampled. If SDA is sampled low, a bus collision has

occurred. This is due to another master attempting to

drive a data ‘0’ (Figure 24-37). If the SCL pin is sampled

low before SDA is allowed to float high, a bus collision

occurs. This is another case of another master

attempting to drive a data ‘0’ (Figure 24-38).

FIGURE 24-38:

BUS COLLISION DURING A STOP CONDITION (CASE 1)

FIGURE 24-39:

BUS COLLISION DURING A STOP CONDITION (CASE 2)

SDA

SCL

BCL1IF

PEN

SSP1IF

TBRG

SDA asserted low

SDA sampled

low after TBRG,

set BCL1IF

’0’

SDA

SCL

BCL1IF

PEN

SSP1IF

TBRG

Assert SDA

SCL goes low before SDA goes high,

set BCL1IF

’0’

PIC12F1822-I/MF 데이터시트(PDF) 271 Page - Microchip Technology

PIC12F1822-I/MF 데이터시트(HTML) 271 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL