PIC18F4580-ESLASHML datasheet(294/490 Pages) MICROCHIP

294 / 490 page

PIC18F2480/2580/4480/4580

DS39637D-page 294

bit 2

Mode 0:

RXB0DBEN: Receive Buffer 0 Double-Buffer Enable bit

1 = Receive Buffer 0 overflow will write to Receive Buffer 1

0 = No Receive Buffer 0 overflow to Receive Buffer 1

Mode 1, 2:

FILHIT2: Filter Hit bit 2

This bit combines with other bits to form filter acceptance bits<4:0>.

bit 1

Mode 0:

JTOFF: Jump Table Offset bit (read-only copy of RXB0DBEN)(2)

1 = Allows jump table offset between 6 and 7

0 = Allows jump table offset between 1 and 0

Mode 1, 2:

FILHIT1: Filter Hit bit 1

This bit combines with other bits to form filter acceptance bits<4:0>.

bit 0

Mode 0:

FILHIT0: Filter Hit bit 0

This bit indicates which acceptance filter enabled the message reception into Receive Buffer 0.

1 = Acceptance Filter 1 (RXF1)

0 = Acceptance Filter 0 (RXF0)

Mode 1, 2:

FILHIT0: Filter Hit bit 0

This bit, in combination with FILHIT<4:1>, indicates which acceptance filter enabled the message reception

into this receive buffer.

01111 = Acceptance Filter 15 (RXF15)

01110 = Acceptance Filter 14 (RXF14)

...

00000 = Acceptance Filter 0 (RXF0)

Note 1:

This bit is set by the CAN module upon receiving a message and must be cleared by software after the

buffer is read. As long as RXFUL is set, no new message will be loaded and buffer will be considered full.

After clearing the RXFUL flag, the PIR3 bit, RXB0IF, can be cleared. If RXB0IF is cleared, but RXFUL is

not cleared, then RXB0IF is set again.

This bit allows same filter jump table for both RXB0CON and RXB1CON.

PIC18F4580-E/ML 데이터시트(PDF) 294 Page - Microchip Technology