AT90PWM2 datasheet(218/361 Pages) ATMEL

218 / 361 page

218

4317J–AVR–08/10

AT90PWM2/3/2B/3B

19.4.4

Sending 17 Data Bit Frames

In this configuration the seventeenth bit shoud be loaded in the RXB8 bit register, the rest of the

most significant bits (9, 10, 11, 12, 13, 14, 15 and 16) should be loaded in the EUDR register,

before the low byte of the character is written to UDR.

19.4.5

Transmitter Flags and Interrupts

The behavior of the EUSART is the same as in USART mode (See “Receive Complete Flag and

Interrupt”).

The interrupts generation and handling for transmission in EUSART mode are the same as in

USART mode.

19.4.6

Disabling the Transmitter

The disabling of the Transmitter (setting the TXEN to zero) will not become effective until ongo-

ing and pending transmissions are completed, i.e., when the Transmit Shift Register and

Transmit Buffer Register do not contain data to be transmitted.

19.4.7

Data Reception – EUSART Receiver

19.5

Data Reception – EUSART Receiver

The EUSART Receiver is enabled by writing the Receive Enable (RXEN) bit in the UCSRB Reg-

ister to one (same as USART). When the Receiver is enabled, the normal pin operation of the

RxD pin is overridden by the EUSART and given the function as the Receiver’s serial input. The

baud rate, mode of operation and frame format must be set up once before any serial reception

can be done. If synchronous operation is used, the clock on the XCK pin will be used as transfer

clock.

19.5.1

Receiving Frames with 5 to 8 Data Bits

In this mode the behavior is the same as the standard USART (See “Receiving Frames with 5 to

8 Data Bits” in USART section).

19.5.2

Receiving Frames with 9, 13, 14, 15 or 16 Data Bits

In these configurations the most significant bits (9, 13, 14, 15 or 16) should be read in the EUDR

Read status from EUCSRC, then data from UDR.

AT90PWM2 데이터시트(PDF) 218 Page - ATMEL Corporation