PIC12F635ESS datasheet(118/234 Pages) MICROCHIP

118 / 234 page

PIC12F635/PIC16F636/639

DS41232D-page 116

11.31.3

RECEIVED SIGNAL STRENGTH

INDICATOR (RSSI) OUTPUT

An analog current is available at the LFDATA pin when

the Received Signal Strength Indicator (RSSI) output is

selected for the AFE’s Configuration register. The analog

current is linearly proportional to the input signal strength

(see Figure 11-15).

All timers in the circuit, such as inactivity timer, alarm

timer, and AGC settling time, are disabled during the

RSSI mode. Therefore, the RSSI output is not affected

by the AGC settling time, and available immediately

when the RSSI option is selected. The AFE enters

Active mode immediately when the RSSI output is

selected. The MCU I/O pin (RC3) connected to the

LFDATA pin, must be set to high-impedance state

during the RSSI Output mode.

When the AFE receives an SPI command during the

RSSI output, the RSSI mode is temporary disabled

until the SPI interface communication is completed. It

returns to the RSSI mode again after the SPI interface

communication is completed. The AFE holds the RSSI

mode until another output type is selected (CS low

turns off the RSSI signal). To obtain the RSSI output

for a particular input channel, or to save operating

power, the input channel can be individually enabled

or disabled. If more than one channel is enabled, the

RSSI output is from the strongest signal channel.

There will be no valid output if all three channels are

disabled.

Related AFE Configuration register bits:

• Configuration Register 1 (Register 11-2),

DATOUT<8:7>:

bit 8

bit 7

: Demodulated Output

: Carrier Clock Output

: RSSI Output

• Configuration Register 2 (Register 11-3),

RSSIFET<8>:

: Pull-Down MOSFET off

: Pull-Down MOSFET on.

• Configuration Register 0 (Register 11-1): all bits

are affected.

FIGURE 11-14:

RSSI OUTPUT PATH

Note:

The pull-down MOSFET option is valid

only when the RSSI output is selected.

The MOSFET is not controllable by users

when Demodulated or Carrier

Clock

output option is selected.

RSSI Output Current

Generator

VDD

(controlled by Config. 2, bit 8)

RSSI Pull-down MOSFET

Current Output

RC3/LFDATA/RSSI/CCLK Pin

RSSIFET

Off

if RSSI active

PIC12F635ESS 데이터시트(PDF) 118 Page - Microchip Technology

PIC12F635ESS 데이터시트(HTML) 118 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL