ST7MC1K2TC datasheet(234/308 Pages) STMICROELECTRONICS

234 / 308 page

ST7MC1/ST7MC2

234/308

OP-AMP MODULE (Cont’d)

10.7.6 Low power modes

Note: The Op-Amp can be disabled by resetting

the OAON bit. This feature allows reduced power

consumption when the amplifier is not used.

10.7.7 Interrupts

None.

10.7.8 Register Description

CONTROL/STATUS REGISTER (OACSR)

Read/Write (except bit 7 read only)

Reset Value: 0000 0000(00h)

Bit 7 = CMPOVR Compensation Completed

This read-only bit contains the offset compensa-

tion status.

0: No offset compensation if OFFCMP = 0, or

Offset compensation cycle not completed if

OFFCMP = 1

1: Offset compensation completed if OFFCMP = 1

Bit 6 = OFFCMP Offset Compensation

0: Reset offset compensation values

1: Request to start offset compensation

Bit 5 = AVGCMP Average Compensation

0: One-shot offset compensation

1: Average offset compensation over 16 times

Bit 4 = OAON Amplifier On

0: Op-Amp powered off

1: Op-Amp on

Bit 3 = HIGHGAIN Gain range selection

This bit must be programmed depending on the

application. It can be used to ensure 35dB open

loop gain when high, it must be low when the

closed loop gain is below 20dB for stability rea-

sons.

0: Closed loop gain up to 20dB

1: Closed loop gain more than 20dB

Bits 2:0 = Reserved, must be kept cleared.

Mode

Description

WAIT

No effect on Op-Amp

HALT

Op-Amp disabled

After wake-up from Halt mode, the Op-

Amp requires a stabilization time (see

Electrical characteristics) (to be defined)

CMP

OVR

OFF

CMP

AVG

CMP

OAO

HIGH

GAIN

ST7MC1K2TC 데이터시트(PDF) 234 Page - STMicroelectronics

ST7MC1K2TC 데이터시트(HTML) 234 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL