ST72361AR4-Auto datasheet(160/279 Pages) STMICROELECTRONICS

160 / 279 page

LINSCI serial communication interface (LIN master/slave)

ST72361xx-Auto

160/279

Doc ID 12468 Rev 3

Character transmission

During an SCI transmission, data shifts out least significant bit first on the TDO pin. In this

mode, the SCIDR register consists of a buffer (TDR) between the internal bus and the

transmit shift register (see Figure 77).

Procedure

●

Select the M bit to define the word length.

●

Select the desired baud rate using the SCIBRR and the SCIETPR registers.

●

Set the TE bit to send a preamble of 10 (M = 0) or 11 (M = 1) consecutive ones (Idle

Line) as first transmission.

●

Access the SCISR register and write the data to send in the SCIDR register (this

sequence clears the TDRE bit). Repeat this sequence for each data to be transmitted.

Clearing the TDRE bit is always performed by the following software sequence:

An access to the SCISR register

A write to the SCIDR register

The TDRE bit is set by hardware and it indicates:

●

The TDR register is empty.

●

The data transfer is beginning.

●

The next data can be written in the SCIDR register without overwriting the previous

data.

This flag generates an interrupt if the TIE bit is set and the I[|1:0] bits are cleared in the CCR

When a transmission is taking place, a write instruction to the SCIDR register stores the

data in the TDR register and which is copied in the shift register at the end of the current

transmission.

When no transmission is taking place, a write instruction to the SCIDR register places the

data directly in the shift register, the data transmission starts, and the TDRE bit is

immediately set.

When a character transmission is complete (after the stop bit) the TC bit is set and an

interrupt is generated if the TCIE is set and the I[1:0] bits are cleared in the CCR register.

Clearing the TC bit is performed by the following software sequence:

An access to the SCISR register

A write to the SCIDR register

Note:

The TDRE and TC bits are cleared by the same software sequence.

Break characters

Setting the SBK bit loads the shift register with a break character. The break character

length depends on the M bit (see Figure 78)

As long as the SBK bit is set, the SCI sends break characters to the TDO pin. After clearing

this bit by software, the SCI inserts a logic 1 bit at the end of the last break character to

guarantee the recognition of the start bit of the next character.

ST72361AR4-Auto 데이터시트(PDF) 160 Page - STMicroelectronics

ST72361AR4-Auto 데이터시트(HTML) 160 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL