M24C02-RDS3TP
AI

## Technical Overview of the M24C02-RDS3TP
The **M24C02-RDS3TP** is a 2-Kbit serial I²C (Inter-Integrated Circuit) Electrically Erasable Programmable Read-Only Memory (EEPROM) manufactured by **STMicroelectronics**. It is widely used for non-volatile data storage in consumer electronics and industrial applications.
### 1. Key Specifications
The following table highlights the primary electrical and physical characteristics:
| Feature | Specification |
| :--- | :--- |
| **Memory Size** | 2 Kbit (256 x 8 bits) |
| **Interface** | I²C (Serial 2-wire) |
| **Operating Voltage** | 1.8V to 5.5V |
| **Clock Frequency** | 400 kHz (Fast Mode) |
| **Package Type** | TSSOP8 (Thin Shrink Small Outline Package) |
| **Operating Temperature** | -40°C to +125°C |
| **Write Endurance** | 4 million write cycles |
| **Data Retention** | 200 Years |
---
### 2. Pin Configuration (TSSOP8)
The device typically follows the standard 8-pin EEPROM pinout:
1. **E0, E1, E2:** Chip Enable inputs (used to set the device address).
2. **Vss:** Ground.
3. **SDA:** Serial Data (bidirectional).
4. **SCL:** Serial Clock.
5. **WC:** Write Control (Hardware protection).
6. **Vcc:** Power Supply.
---
### 3. Functional Breakdown
#### A. Memory Organization
The 2-Kbit memory is organized as **256 bytes**. Because the address space is small (00h to FFh), the entire memory can be addressed using a single byte during I²C communication.
#### B. The "WC" (Write Control) Pin
This is a hardware safety feature:
* If **WC** is connected to **Vss** (Ground), the entire memory is unprotected (Write operations allowed).
* If **WC** is connected to **Vcc**, the entire memory is write-protected (Read-only mode).
#### C. I²C Protocol Support
The device supports:
* **Byte Write:** Writing a single byte of data.
* **Page Write:** Writing up to 16 bytes in a single operation.
* **Random Read:** Reading a byte from a specific address.
* **Sequential Read:** Reading the entire memory content in one go.
---
### 4. Part Number Decoding
Understanding the suffix **"RDS3TP"**:
* **M24C02:** 2 Kbit I²C EEPROM.
* **-R:** 1.8V to 5.5V supply voltage.
* **DS:** TSSOP8 package (ECOPACK2 compliant).
* **3:** Range 3 temperature (-40 to +125°C).
* **TP:** Tape and Reel packaging.
---
- ⤷
What are the differences between M24C02 and M24C04 in terms of addressing?
- ⤷ How do I calculate the I2C slave address using the E0
- ⤷ E1
- ⤷ and E2 pins?
- ⤷ Can this EEPROM be used with a 3.3V microcontroller like an ESP32 or STM32?