전자부품 데이터시트 검색엔진
  Korean  ▼
ALLDATASHEET.CO.KR

X  

  • TSOP146..

  • AI
    The **TSOP146** series consists of miniaturized receivers for infrared (IR) remote control systems. These components integrate a PIN diode and a preamplifier into a single lead frame, while the epoxy package acts as an IR filter. --- ## 1. Internal Functional Block Diagram The TSOP146 contains several electronic stages to process weak IR signals into clean digital pulses. | Stage | Function | | :--- | :--- | | **PIN Diode** | Converts incoming IR light into a small electrical current. | | **Preamplifier** | Amplifies the weak signal from the photodiode. | | **AGC (Automatic Gain Control)** | Adjusts sensitivity to suppress noise from ambient light (fluorescent lamps, sunlight). | | **Band Pass Filter** | Filters the signal to only allow a specific carrier frequency (e.g., 38kHz). | | **Demodulator** | Removes the carrier wave to leave only the data signal. | | **Output Stage** | Typically an NPN transistor that pulls the signal to Ground (Active Low). | --- ## 2. Technical Specifications The TSOP146 belongs to a family where the last two digits often denote the carrier frequency. | Parameter | Value (Typical) | | :--- | :--- | | **Supply Voltage ($V_S$)** | 2.5 V to 5.5 V | | **Supply Current ($I_S$)** | 0.7 mA | | **Carrier Frequency ($f_o$)** | 30 kHz to 56 kHz (Standard is often 38kHz) | | **Transmission Distance** | Up to 45 meters | | **Output Type** | Active Low (Logic 0 when IR is detected) | --- ## 3. Pin Configuration The TSOP146 typically uses a 3-pin layout. **Note:** Always verify the specific datasheet for the sub-variant, as some pinouts are mirrored. ```text _________ / \ | ( O ) | <-- IR Sensor Window \_________/ | | | 1 2 3 1: OUT (Data Signal) 2: GND (Ground) 3: Vs (Power Supply) ``` --- ## 4. Typical Application Circuit To ensure stable operation and noise immunity, a small RC filter is recommended on the supply line. ```c // Basic Hardware Connection Vs (Pin 3) <-- [ 100 Ohm Resistor ] <-- 5V DC | [ 4.7uF Capacitor ] -- to GND | GND (Pin 2) <-- Ground OUT (Pin 1) <-- Microcontroller GPIO (Internal Pull-up enabled) ``` --- ## 5. Key Design Features * **High Immunity to Noise:** Specially designed to ignore "optical noise" from energy-saving lamps (CFLs). * **Low Power Consumption:** Ideal for battery-operated devices. * **TTL/CMOS Compatibility:** The output can be directly connected to an Arduino, ESP32, or Raspberry Pi without level shifting.
    ✨ Follow-up Questions
    • ⤷ What is the difference between the TSOP146 and the TSOP1738?
    • ⤷ How do I troubleshoot a TSOP146 that is not responding to a remote?
    • ⤷ Can the TSOP146 be used for continuous data transmission or only for bursts?