Overview
2EG01XCxN11N is a dual channel gate driver designed for IGBT power module.
This gate driver unit contains a built-in isolated DC/DC converter and gate drive circuit.
After mounting the gate resistors, It is ready to use by mounting it on the IGBT power module.

Features
・Ideal for drive of IGBT Power module
・Gate voltage : +15V/-10V
・Gate resistor : Open (lead resistor mounting possible)
・Short circuit detection voltage : 10V(TYP)
・ALL-IN-ONE (Built-in isolated DC / DC converter and gate drive circuit)
・Low parasitic capacitance (12pF(TYP)) ; highly resistant to common-mode noise.
・Fast response : About 130nsec(typ)
・The isolation for primary-secondary signal used fast response isolator.
・Dielectric withstand voltage : AC5000V
・Insulation distance (clearance / creepage) : 14mm/16mm (As for Gate driver PCB) *Refer to P6 for details
・DC/DC converter input voltage : 13～28V
・Power supply for gate driver input voltage : 13～28V
・Signal input voltage : 3.3～15V or 15V
・Overload protection (DC/DC converter)
・Overheat protection (DC/DC converter)
・Desaturation protection (Gate drive circuit)
・Soft turn-off function (Gate drive circuit)
・Fault signal output function (Gate drive circuit)
・Under-voltage lockout(UVLO) (Gate drive circuit)
・Direct mode / Half bridge mode can be switched. (Gate drive circuit)
・Safety standards：UL508(file no.E243511) (DC/DC converter only)
・Reinforced isolation according to IEC 60664-1 (IEC61800-5-1, IEC62477-1, IEC62109-1, etc.)
・UL compliant (UL1741, UL508, etc.)

Application
Industrial inverter, power conditioner, etc.