Introduction
The EZ-USB NX2LP™ (NX2LP) implements a USB 2.0 NAND Flash controller. This controller adheres to the Mass Storage Class Bulk-Only Transport Specification. The USB port of the NX2LP is connected to a host computer directly or via the downstream port of a USB hub. Host software issues commands and data to the NX2LP and receives status and data from the NX2LP using standard USB protocol.
The NX2LP supports industry leading 8-bit NAND Flash interfaces and both common NAND page sizes of 512 and 2k bytes. Eight chip enable pins allow the NX2LP to be connected to up to eight single- or four dual-device NAND Flash chips.
Certain NX2LP features are configurable, enabling the NX2LP to meet the needs of different designs’ requirements.

Features
• High (480-Mbps) or full (12-Mbps) speed USB support
• Both common NAND page sizes supported
   — 512bytes –Up to 1Gbit Capacity
   — 2K bytes –Up to 8Gbit Capacity
• 8 chip enable pins
   — Up to 8 NAND Flash single-device chips
   — Up to 4 NAND Flash dual-device chips
• Industry standard ECC NAND Flash correction
   — 1-bit per 256 correction
   — 2-bit error detection
• Industry standard (SmartMedia) page management for
   wear leveling algorithm, bad block handling, and Physical
   to Logical management.
• Supports 8-bit NAND Flash interfaces
• Supports 30ns, 50ns, 100ns NAND Flash timing
• Complies with USB Mass Storage Class Specification rev 1.0
• CY7C68024 complies with USB 2.0 Specification for Bus
   Powered Devices (TID# 40460274)
• 43-mA Typical Active Current
• Space-saving and lead-free 56-QFN package (8mm × 8mm)
• Support for board-level manufacturing test via USB interface
• 3.3V NAND Flash operation
• NAND Flash power management support