[Genesys-Logic]

Overview
The GL711FW is a high-performance 1394 to ATA/ATAPI native bridge with an embedded SBP-2 target solution. It supports a solution for link/transaction layer controller conforming to the IEEE Std 1394 (IEEE 1394-1995 and IEEE 1394.a) up to 400Mbps transfer rate. Through the SBP-2 port driver, supported by Microsoft Windows 2000 and Windows 98 SE, Windows ME, SCSI class drivers can use SBP-2 to communicate with IEEE 1394 device using the SCSI command set.

Features
● Data transfer rates of S100, S200 and S400
● Fully interoperable with implementation of IEEE-1394(1995) and IEEE 1394.a-2000 compliant
● Standard PHY/link Interface
● Firmware support for SBP-2 target agent
● Fully ATA/ATAPI-6 compliant.
● Supports IDE PIO modes and DMA modes and Ultra DMA modes up to UDMA100.
● Embedded RAM, ROM and micro-processor.
● External Flash ROM interface for easy updating firmware code.
● Automatic SBP-2 protocol management by an internal hardware engine to improve performance and firmware efficiency
● Auto acknowledge-code response for all packets that targeted to Management/Command ORB agent SBP-2 protocol engine:
   - Automatic Management ORB fetch
   - Linked Command ORB fetch
   - Auto address increment DMA for both direct and indirect addressing
● Automatic Page Table fetching
● Dedicated asynchronous data transfer
● Automatic packing/de-packing for asynchronous transmit/receive data of DMA
● Automatic single-retry protocol and split transaction control.
● 2 sets of 4-quadlet registers for Asynchronous Receive/Transmit packet header
● 2 sets of 8-quadlet registers for general Asynchronous Receive/Transmit packet data block payload
● 5 sets of 8/8/2/2/2-quadlet registers for Receive packet data block payload dedicated for SBP-2 requirement (MORB,
● CORB, PTE, MOP and COP)
● 4K bytes of FIFO for bi-directional transmit/receive data