[Features]
• High quality ESD bench matting
• Reflection breaking surface to reduce glare and improve operator comfort
• Protection against small collisions thanks to natural resilience of rubber
• Prevents sliding of delicate components thanks to excellent friction coefficient
• Heat resistant: rubber does not melt or burn coming into contact with hot metal
parts or soldering debris
• Resistant to chemical agents normally used for maintenance
• Oil resistance: this product resists most oils
• Suitable for loose laying: does not require application with adhesive
• Good resistance to scratches
• Excellent flexibility and comfort
• Cut mats available on request
• European origin
• Studs sold separately (not included)
Grounding:
Sufficient ground cords should be used to reliably meet EN 61340-5-1 Table 3 less than 1 × 109 ohms for working surfaces.
Industry recommendation is that continuous runs of ESD matting should be grounded at 10ft intervals to allow proper charge
decay rates. Each individual ESD mat should be grounded with ground snaps located no further than five feet from either end.
Cleaning:
Please note that contact between the matting surface and any acid or alkali solvent is strictly prohibited (such as Benzene,
Alcohol etc), this will result in the antistatic performance wearing away. If cleaning is required, the matting may be wiped with a
cloth coated in a neutral solution (such as water).
Guidance on Use:
Matting materials have a tendency to shrink slightly when first unrolled. In applications where length is critical, allow the material
to relax for at least 4 hours before cutting to size. Matting should always be trimmed with a sharp knife or razor blade.
Cutting Tolerances:
Width ±6mm
Length ±6mm every linear foot of running material