Description
The CXP913040 is a CMOS 16-bit microcomputer integrating on a single chip an A/D converter, serial interface with an incorporated buffer RAM, highprecision timing pattern generation function, pulse cycle measurement circuit, PWM generator, generalpurpose prescaler, vertical sync separation circuit, and a measurement circuit which measures the signals of capstan FG, drum FG/PG, reel FG and other servo systems with high precision, as well as basic configurations like a 16-bit CPU, ROM, RAM, and I/O port.
This LSI also provides sleep/stop modes that enable lower power consumption.

Features
• An efficient instruction set as a controller
   — Direct addressing, numerous abbreviated forms, multiplication and division instructions
• Instruction sets for C language and RTOS
   — Highly quadratic instruction system, general-purpose register of 16-bit × 8-pin × 16-bank configuration
• Minimum instruction cycle time 100ns at 20MHz operation
• Incorporated ROM capacity 160K bytes
• Incorporated RAM capacity 6144 bytes
• Peripheral functions
   — A/D converter 8-bit 12-channel successive approximation system, automatic
      scanning function, 8-stage (soft) + 4-stage (hard) FIFO for
      conversion results (Conversion time: 20µs at 20MHz)
   — Serial interface Buffer RAM (128 bytes, supports high-speed transfer mode),
      3 channels
   — Timers 8-bit timer/counter + 8-bit timer (with timing output), 1 channel
      16-bit capture timer/counter (with timing output), 1 channel
      16-bit timer, 4 channels
   — High-precision timing pattern generator PPG for 27 pins, 42 stages (max.)
      PPG for 16 pins, 16 stages (max.)
      RTG for 5 pins, 3 channels
   — PWM/DA gate output PWM for 14 bits, 2 channels
      (Repetitive frequency of 39.1kHz, 20MHz)
      DA gate pulse for 14 bits, 2 channels
   — Servo input control Capstan FG, drum FG/PG, reel FG
   — VSYNC separator
   — FRC capture unit 24-bit and 8-stage FIFO
   — PWM output 14 bits, 2 channels
   — General-purpose prescaler 10 bits, 1 channel
   — Pulse cycle measurement circuit 1 channel with mask input
• General-purpose I/O 80 pins
   (max.; when all multi-purpose pins are used as general-purpose I/O.)
• Interruption 28 factors, 28 vectors, multi-interruption and priority selection
   possible
• Standby mode Sleep/stop
• Package 100-pin plastic LQFP
• Piggy/evaluation chip CXP913000 100-pin ceramic LQFP