UM2153 datasheet(22/57 Pages) STMICROELECTRONICS

22 / 57 page

Hardware layout and configuration

UM2153

22/57

DocID030118 Rev 3

Figure 14. SPSGRF module

The main features of the ST SPSGRF module are listed below.

•

Programmable radio features:

–

Based on Sub-1GHz SPIRIT1 transceiver and integrated Balun (BALF-SPI-01D3)

–

Modulation schemes: 2-FSK, GFSK, MSK, GMSK, OOk and ASK

–

Air data rate from 1 to 500 kbps

–

On-board antenna

•

Programmable RF output power up to +11.6 dBm

•

Host interface: SPI

•

General I/O (up to 32 programmable I/O functions on 4 GPIO programmable module

pins

•

Two typical carrier frequency versions:

–

SPSGRF-868 with 868 MHz tuned antenna

–

SPSGRF-195 with 915 MHz tuned antenna

7.11.3

Wi-Fi module Inventek ISM43362-M3G-L44 (802.11 b/g/n)

The Inventek ISM43362-M3G-L44 module (M2) is implemented on top side of the STM32L4

Discovery kit for IoT node board. This module is an embedded (eS-WiFi) wireless Internet

Connectivity device. The Wi-Fi module hardware consists of an ARM® Cortex® -M3 STM32

host processor, an integrated antenna (or optional external antenna) and a Broadcom Wi-Fi

device. The module uses either a UART (UART3 of STM32L475VG) or an SPI (SPI3 of

STM32L475VG) interface. As default, an SPI interface is used, as the corresponding

firmware (for SPI capability) is downloaded on the Wi-Fi ISM43362-M3G-L44 module. The

Wi-Fi module requires no operating system and has a completely integrated TCP/IP stack

that only requires AT commands to establish connectivity for wireless product. The foot print

of this module is 14.5 mm x 30 mm.

UM2153 데이터시트(PDF) 22 Page - STMicroelectronics