BCM4339 datasheet(21/133 Pages) CYPRESS

21 / 133 page

Document No. 002-14784 Rev. *H

Page 21 of 133

PRELIMINARY

CYW4339

5.3 Link Control Layer

The link control layer is part of the Bluetooth link control functions that are implemented in dedicated logic in the link control unit (LCU).

This layer consists of the command controller that takes commands from the software, and other controllers that are activated or

configured by the command controller to perform the link control tasks. Each task performs a different state in the Bluetooth Link

Controller.

■ Major states:

❐ Standby

❐ Connection

■ Substates:

❐ Page

❐ Page Scan

❐ Inquiry

❐ Inquiry Scan

❐ Sniff

5.4 Test Mode Support

The CYW4339 fully supports Bluetooth Test mode as described in Part I:1 of the Specification of the Bluetooth System Version 3.0.

This includes the transmitter tests, normal and delayed loopback tests, and reduced hopping sequence.

In addition to the standard Bluetooth Test Mode, the CYW4339 also supports enhanced testing features to simplify RF debugging,

qualification, and type-approval testing. These features include:

■ Fixed-frequency carrier-wave (unmodulated) transmission

❐ Simplifies some type-approval measurements (Japan)

❐ Aids in transmitter performance analysis

■ Fixed-frequency constant-receiver mode

❐ Receiver output directed to I/O pin

❐ Allows for direct BER measurements using standard RF test equipment

❐ Facilitates spurious emissions testing for receive mode

■ Fixed frequency constant transmission

❐ Eight-bit fixed pattern or PRBS-9

❐ Enables modulated signal measurements with standard RF test equipment

BCM4339 데이터시트(PDF) 21 Page - Cypress Semiconductor