8/10

Part No. : LTW-R4NLDJDJH239

BNS-OD-FC002/A4

Through Hole Lamp

LTW-R4NLDJDJH239

8. CAUTIONS

8.1. Application

This LED lamp is good for application of indoor and outdoor sign, also ordinary electronic equipment.

8.2. Storage

The storage ambient for the LEDs should not exceed 30°C temperature or 70% relative humidity. It is recommended that

LEDs out of their original packaging are used within three months. For extended storage out of their original packaging, it is

recommended that the LEDs be stored in a sealed container with appropriate desiccant or in desiccators with nitrogen

ambient.

8.3. Cleaning

Use alcohol-based cleaning solvents such as isopropyl alcohol to clean the LEDs if necessary.

8.4. Lead Forming & Assembly

During lead forming, the leads should be bent at a point at least 3mm from the base of LED lens. Do not use the base of the

lead frame as a fulcrum during forming. Lead forming must be done before soldering, at normal temperature. During assembly

on PCB, use minimum clinch force possible to avoid excessive mechanical stress.

8.5. Soldering

When soldering, leave a minimum of 2mm clearance from the base of the lens/Holder to the soldering point. Dipping the

lens/Holder into the solder must be avoided. Do not apply any external stress to the lead frame during soldering while the LED

is at high temperature.

Recommended soldering conditions:

Soldering iron

Wave soldering

Temperature

Soldering time

Position

350°C Max.

3 seconds Max.

(one time only)

No closer than 2mm

from the base of the epoxy bulb

Pre-heat

Pre-heat time

Solder wave

Soldering time

Dipping Position

120°C Max.

100 seconds Max.

260°C Max.

5 seconds Max.

No lower than 2mm from the

base of the epoxy bulb

Note: Excessive soldering temperature and/or time might result in deformation of the LED lens or catastrophic

failure of the LED.

8.6. Drive Method

An LED is a current-operated device. In order to ensure intensity uniformity on multiple LEDs connected in parallel in an

application, it is recommended that a current limiting resistor be incorporated in the drive circuit, in series with each LED as

shown in Circuit A below.

Circuit model (A)

Circuit model (B)

LED

LED

(A) Recommended circuit

(B) The brightness of each LED might appear different due to the differences in the I-V characteristics of those LEDs.