Master

SCL Line

Data from

Transmitter

ACK

ACK from

Receiver

Bit 9

Bit 1

Figure 1-8. Acknowledge Response From Receiver

•

Slave Address : After the master initiates a Start condition, it must output the address of the device to be

accessed. The most significant four bits of the slave address are called the “device identifier”. The identifier

for the

24LLC02 is “1010B”. The next three bits comprise the address of a specific device. The device

address is defined by the state of the A0, A1 and A2 pins. Using this addressing scheme, you can cascade

up to eight 24LLC02 on the bus (see Table 1-2 below).are used by the master to select which of the blocks

of internal memory (1 block= 256 words) are to be accessed. The bits are in effect the most significant bits

of the word address.

•

Read/Write : The final (eighth) bit of the slave address defines the type of operation to be performed. If the

Table 1-2. Slave Device Addressing

Device

Device Identifier

Device Address

W

Bit

b7

b6

b5

b4

b3

b2

b1

b0

24 LLC 02

1

0

1

0

A2

A1

A0

NOTE:

The B2, B1, B0 correspond to the MSB of the memory array address word.

* All specs and applications shown above subject to change without prior notice.

1F-5 NO.66 SEC.2 NAN-KAN RD ., LUCHU , TAOYUAN, TAIWAN, R.O.C

Email: server@ceramate.com.tw

Tel:886-3-3529445

Http: www.ceramate.com.tw

Fax:886-3-3521052

Page

7 of 19

Rev 1.2 May 6,2002

24LLC02

2K-bit Serial EEPROM for Low Power