SPDT RF Switch

HSWA2-63DR+

Page 4 of 5

Notes

A. Performance and quality attributes and conditions not expressly stated in this specification document are intended to be excluded and do not form a part of this specification document.

B. Electrical specifications and performance data contained in this specification document are based on Mini-Circuit’s applicable established test performance criteria and measurement instructions.

C. The parts covered by this specification document are subject to Mini-Circuits standard limited warranty and terms and conditions (collectively, “Standard Terms”); Purchasers of this part are entitled

to the rights and benefits contained therein. For a full statement of the Standard Terms and the exclusive rights and remedies thereunder, please visit Mini-Circuits’ website at www.minicircuits.com/MCLStore/terms.jsp

Parameter

Ratings

Operating temperature

-40°C to +105°C

Storage temperature

-65°C to 150°C

V

-0.3 to 5.5V

Voltage control

-0.3V Min. 3.6 Max.

+30 dBm

+20 dBm

Maximum Die Junction Temperature

150°C

Truth Table

Mode

State of Control voltage

Control 1

Control 2

RF COM-RF1 ON

HIGH

LOW

RF COM-RF2 ON

LOW

HIGH

ALL OFF

LOW

LOW

Unsupported

HIGH

HIGH

5. Operation of this device above any of these conditions may cause permanent damage.

6. 100% Duty Cycle, all band, 50

Ω

Characterization / Application Test Circuit

Figure 2. Block Diagram of test Circuit used for characterization

(DUT soldered on Mini-Circuits’ TB-919+)

Note: Cblock is required only when DC is present on RF ports.