EVQ6526-R-00A _0.9A, 28V SIX HALF-BRIDGE MOTOR DRIVER EVALUATION BOARD

NOTICE: The information in this document is subject to change without notice. Users should warrant and guarantee that third

party Intellectual Property rights are not infringed upon when integrating MPS products into any application. MPS will not

assume any legal responsibility for any said applications.

EVQ6526-R-00A Rev. 1.0

www.MonolithicPower.com

6

12/22/2016

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2016 MPS. All Rights Reserved.

QUICK START GUIDE

1. Power Requirements

a. Power supply range: 7V to 28V, 3A Max.

VIN

GND

MP6526 Demo Board

MPS

SW1

CN1

U2

EV6526-R-00A

VS

OUT6

OUT5

OUT4

OUT3

OUT2

OUT1

GND

CN4

CN7

SW2

S1

S2

S3

S4

S5

S6

S7

S8

OFF

ON

3.3V

5V

GND

DI

CLK

CS

DO

Figure 3

— EVQ6526-R-00A Bird’s-eye View

2. Setup Condition

a. Adjust the power supply VIN with recommended operating range (7V to 28V).

b. Input for VCC power supply is on board (5V or 3.3V, use SW1 to adjust).

c. Easy adaptation of loads by CN4 - CN7.

d. EN alternatively connected to VCC or GND, selected by S8 of SW2.

e. Serial data interface control via CN1 connectors.

3. Monitors

a. For full-bridge application, indicate rotation direction of DC motors can be observed by LEDs if

S1

– S5 of SW2 switches ON position.

b. All pins are easily accessible via test points.

c. A low output at FAULT indicates that the IC has detected an over-temperature or over-current

condition.