PAM8904JPR datasheet(5/9 Pages) DIODES

5 / 9 page

PAM8904

Document number: DS37246 Rev. 2 - 2

5 of 9

www.diodes.com

May 2017

PAM8904

Application Information

Charge Pump Mode Setting

The Charge Pump Mode (CPM) pins EN1 and EN2 are used to set the charge pump into mode 1x VDD, 2x VDD, 3x VDD or they can be used to put

the PAM8904 in to a forced low current shutdown mode.

DIN

EN1

EN2

MODE

—

Shutdown Mode

1x Mode

2x Mode

3x Mode

Care must be taken when using the 3x mode with a VDD supply of 5V or more, as this will force the VOUT to exceed its Absolute Maximum

specification (15V).

Timing Chart and Device Operation

When one or both of the EN pins are pulled high, the device enters normal operation mode, refer to the above table for the mode selection. Once the

PAM8904 senses a valid signal on the DIN pin, the charge pump will start and provide the desired voltage on the VOUT pin and the output drive

VO1 and VO2 start to function after time tON which is typically between 270µs and 350µs depending on the mode chosen. Once the input signal on

DIN is removed, the PAM8904 senses this and waits typically 42ms to ensure the signal has been removed. If there is no further valid signal within

the time period tOFF, the PAM8904 enters into a low current standby mode.

Timing Chart

VDD Range

Mode

2.3V to 5.5V

1x, 2x and 3x

tON

tOFF

PAM8904JPR 데이터시트(PDF) 5 Page - Diodes Incorporated