Wound Rod Inductance Calculations

To calculate the inductances of a wound rod the following formula can be used,

 

The inductance modifier is found in Figure 2. The ratio winding length divided by the rod length will give the inductance

modifier. If the rod is totally wound the K=1. Shorter but centered winding will yield higher K values.

 Using the rod 3061990871 as an example.

For this rod the length over diameter ratio is 8.33 and for 61 material Figure 1 gives a µrod of 29. The rod has an AE=

0.0707 cm² and ᵌ=2.5 cm.

A winding of 80 turns of 30 AWG wire will yield a fully wound rod, therefore K=1.

Using the formula the calculated inductance is 65.96µH.

 The measured values for both winding were 66.95 and 39.50µH respectively.