Analysis condition display

Preview display of changed analysis condition

ACCTee detects the maximum point (minimum point) and automatically

shifts the stylus to the maximum point (minimum point ) as the peak and

valley function traces the cylindrical profile, convex, concave, and spheri-

cal profile using the stylus. In manual operation, the position is reported by

an alarm.

Roughness Peak and Valley Detection Function

As the profile traced by the roughness stylus is

displayed, the measurement area can be set on

the screen.

Roughness Curve Trace Display

Level differences can be measured on the

concave and convex profile. The measurement,

average height, maximum height, minimum

height, and area can be calculated from the data.

Level Difference Parameter

The degree of wear can be calculated by overlap-

ping and

displaying two roughness curves and calculating

the differences between the data.

Wear-out Analysis for Roughness Curve Data

Rich measurement/analysis functions Beginner friendly Wide variety of guidance function

Analysis condition change function of ACCTee allows for setting/changing the surface texture parameter calculation standard,

or the cut-off filter, the notch level, the deletion length and so on.

Additionally this allows for setting a freely selected value to the range of waviness data employed for the surface texture parameter calculation.

Preview function implemented in the selection of form removal (tilt correction) allows for selection of the most appropriate form removal condition

The function implemented allows for clearing the setting ranges and conditions easily.

Outstanding high operability

57

TOKYO SEIMITSU