MPC885CZP66 datasheet(15/92 Pages) FREESCALE

15 / 92 page

MPC885/MPC880 Hardware Specifications, Rev. 3

Freescale Semiconductor

Layout Practices

These cautions are necessary for the long-term reliability of the part. If they are violated, the electrostatic discharge

(ESD) protection diodes are forward-biased, and excessive current can flow through these diodes. If the system

power supply design does not control the voltage sequencing, the circuit shown Figure 4 can be added to meet these

requirements. The MUR420 Schottky diodes control the maximum potential difference between the external bus and

core power supplies on power up, and the 1N5820 diodes regulate the maximum potential difference on power

down.

Figure 4. Example Voltage Sequencing Circuit

Layout Practices

Each VDD pin on the MPC885/880 should be provided with a low-impedance path to the board’s supply. Each GND

pin should likewise be provided with a low-impedance path to ground. The power supply pins drive distinct groups

of logic on chip. The VDD power supply should be bypassed to ground using at least four 0.1 µF by-pass capacitors

located as close as possible to the four sides of the package. Each board designed should be characterized and

additional appropriate decoupling capacitors should be used if required. The capacitor leads and associated printed

circuit traces connecting to chip VDD and GND should be kept to less than half an inch per capacitor lead. At a

minimum, a four-layer board employing two inner layers as VDD and GND planes should be used.

All output pins on the MPC885/880 have fast rise and fall times. Printed circuit (PC) trace interconnection length

should be minimized in order to minimize undershoot and reflections caused by these fast output switching times.

This recommendation particularly applies to the address and data buses. Maximum PC trace lengths of six inches

are recommended. Capacitance calculations should consider all device loads as well as parasitic capacitances due to

the PC traces. Attention to proper PCB layout and bypassing becomes especially critical in systems with higher

capacitive loads because these loads create higher transient currents in the VDD and GND circuits. Pull up all unused

inputs or signals that will be inputs during reset. Special care should be taken to minimize the noise levels on the

PLL supply pins. For more information, please refer to the MPC885 User’s Manual, Section 14.4.3, “Clock

Synthesizer Power (VDDSYN, VSSSYN, VSSSYN1)”.

10 Bus Signal Timing

The maximum bus speed supported by the MPC885/880 is 80 MHz. Higher-speed parts must be operated in

half-speed bus mode (for example, an MPC885/880 used at 133 MHz must be configured for a 66 MHz bus). Table 7

shows the frequency ranges for standard part frequencies in 1:1 bus mode, and Table 8 shows the frequency ranges

for standard part frequencies in 2:1 bus mode.

VDDH

VDDL

1N5820

MUR420

MPC885CZP66 데이터시트(PDF) 15 Page - Freescale Semiconductor, Inc