19

PC8240

2149A–HIREL–05/02

Notes:

1. These specifications are for the default driver strengths indicated in Table 7 on page 17.

2. Rise and fall times for the PCI_SYNC_IN input are measured from 0.4 to 2.4V.

3. Specification value at maximum frequency of operation.

4. Relock time is guaranteed by design and characterization. Relock time is not tested.

5. Rise and fall times for the OSC_IN input is guaranteed by design and characterization. OSC_IN input rise and fall times are

not tested.

6. Relock timing is guaranteed by design. PLL-relock time is the maximum amount of time required for PLL lock after a stable

Vdd and PCI_SYNC_IN are reached during the reset sequence. This specification also applies when the PLL has been dis-

abled and subsequently re-enabled during sleep mode. Also note that HRST_CPU/HRST_CTRL must be held asserted for

a minimum of 255 bus clocks after the PLL-relock time during the reset sequence.

7. DLL_EXTEND is bit 7 of the PMC2 register <72>. N is a non-zero integer (1, 2, 3, ...). T

SDRAM_SYNC_OUT clock cycle in ns. t

runner) from SDRAM_SYNC_OUT to SDRAM_SYNC_IN in ns; 6.25 inches of loop length (unloaded PC board runner) cor-

responds to approximately 1 ns of delay. t

DLL is contributing no delay; t

8. Pin to pin skew includes quantifying the additional amount of clock skew (or jitter) from the DLL besides any intentional skew

added to the clocking signals from the variable length DLL synchronization feedback loop, i.e. the amount of variance

between the internal sys-logic_clk and the SDRAM_SYNC_IN signal after the DLL is locked. While pin to pin skew between

SDRAM_CLKs can be measured, the relationship between the internal sys-logic_clk and the external SDRAM_SYNC_IN

cannot be measured and is guaranteed by design.

Figure 8. PCI_SYNC-IN Input Clock Timing Diagram

18

OSC_IN Cycle Time

40

15

ns

19

OSC_IN Rise and Fall Times

–

5

ns

(5)

20

OSC_IN Duty Cycle Measured at 1.4V

40

60

%

21

OSC_IN Frequency Stability

–

100

ppm

22

OSC_IN V

TBD

V

23

OSC_IN V

–

TBD

V

Table 9. Clock AC Timing Specifications (Continued)

Num

Characteristics and Conditions

(1)

Min

Max

Unit

Notes

1

23

5a

5b

VM

VM

VM

CVIL

CVIH

VM = Midpoint Voltage (1.4V)

PCI_SYNC_IN