THIS CATALOG PAGE IS FOR REFERENCE ONLY. REQUEST A

CERTIFIED UMPCO DRAWING FOR ACTUAL SPECIFICATIONS.

ANY

CONFLICT

BETWEEN

THIS

DOCUMENT

AND

THE

CERTIFIED DRAWING, THE CERTIFIED DRAWING WILL TAKE

PRECEDENCE. IF THE DOCUMENT IS CONTROLLED BY ANY

OTHER SOURCE THAN UMPCO, THE CERTIFIED DRAWING MUST

BE PURCHASED THROUGH THAT ORGANIZATION.

CAGE CODE No. 18076

REV

A

7/28/2011

AS9596

BRACKET, ANGLE, 90°, CADMIUM PLATED STEEL, UNSG41300, .190 BOLT

PART NUMBER

7100 LAMPSON AVE * PO BOX 5158 * GARDEN GROVE, CA 92846-5158 SALES: (714) 897-3531 * BUS: (714) 897-3536 * FAX: (714) 897-2611

Ø .210/.200

R .500

.205

.195

.500

A

B

90°

MARK PART

NUMBER AND

MANUFACTURER’S

IDENTIFICATION IAW

AS478 CLASS D

FIGURE 1 ANGLE BRACKET

DIRECTION OF GRAIN

SEE NOTE 6

.255

.245

.068

.056

R .125

R .500

Ø .210/.200

.205

.195

REQUIREMENTS:

1.

MATERIAL: STEEL IN ACCORDANCE WITH AMS 6350, HARDEN (OIL QUENCH) AND TEMPER TO

ROCKWELL 32-38 HRC PER ASTM E18.

2.

FINISH: CADMIUM PLATE IN ACCORDANCE WITH AMS 2400. DIMENSIONS SPECIFIED ARE

AFTER PLATING.

3.

REMOVE BURRS AND BREAK EDGES

4.

APPROXIMATE WEIGHT LB/100 = .877 (A+B) + .157.

5.

TOLERANCES UNLESS OTHERWISE SPECIFIED, TOLERANCES SHALL BE FOR LINEAR

DIMENSIONS ±.010, ANGULAR ±5°.

6.

GRAIN FLOW SHALL BE PARALLEL WITH ROLLING DIRECTION

7.

PART NUMBER: THE PART NUMBER SHALL CONSIST OF THE BASIC MS NUMBER FOLLOWED BY A

DASH NUMBER FROM TABLE 1.

EXAMPLE: MS9596-005

DASH NUMBER

BASIC MS NUMBER

MS9596-005 INDICATES – BRACKET, ANGLE, 90°, STEEL, .190 BOLT,

LENGTH A, .438, LENGTH B, .438.

NOTES:

1.

DIMENSIONS ARE IN INCHES.

WARNING:

THIS DOCUMENT INCLUDES CADMIUM AS A PLATING MATERIAL. THE USE OF CADMIUM HAS BEEN

RESTRICTED AND/OR BANNED FOR USE IN MANY COUNTRIES DUE TO ENVIRONMENTAL AND HEALTH

CONCERNS. THE USER SHOULD CONSULT WITH LOCAL OFFICIALS ON THE ENVIRONMENTAL AND HEALTH

REGULATIONS REGARDING ITS USE.

MS9596-XXX