Specifications

Supply Voltage and Current

90 to 250 V ac (50/60 Hz)

Average current 20 mA

Peak current 500 mA at 120 V ac, 750 mA at 250 V ac

Supply Protection Circuitry

Protected against transient voltages

Output Configuration

SPDT (Single-Pole Double-Throw) electromechanical relay output. All models

except emitters.

Output Rating

Max. switching power (resistive load): 150 W, 600 VA

Max. switching voltage (resistive load): 250 V ac, 30 V dc

Max. switching current (resistive load): 5 A at 250 V ac

Min. voltage and current: 5 V dc, 0.1 mA

Mechanical life of relay: 10,000,000 operations

Electrical life of relay at full resistive load: 100,000 operations

Output Protection Circuitry

Protected against false pulse on power-up

Output Response Time

15 milliseconds ON and OFF

Note: 100 millisecond delay on power-up. Output

is de-energized during this time

Required Overcurrent Protection

WARNING: Electrical connections must be made

by qualified personnel in accordance with local

and national electrical codes and regulations.

Overcurrent protection is required to be provided by end product application

per the supplied table.

Overcurrent protection may be provided with external fusing or via Current

Limiting, Class 2 Power Supply.

Supply wiring leads < 24 AWG shall not be spliced.

For additional product support, go to www.bannerengineering.com.

Supply Wiring (AWG)

Required Overcurrent Protection (Amps)

20

5.0

22

3.0

24

2.0

26

1.0

28

0.8

30

0.5

Repeatability

Opposed mode: 0.25 milliseconds

All other sensing modes: 0.5 milliseconds

Response time and repeatability specifications are independent of signal

strength.

Adjustments

Light/Dark Operate select switch and multi-turn Sensitivity control (allows

precise sensitivity setting – turn clockwise to increase gain).

Optional logic and logic/display modules have adjustable timing functions.

Indicators

top of the sensor

Power (green) LED lights when 90 to 250 V ac power is applied

source and pulses at a rate proportional to the strength of the received light

signal

Load (amber) LED lights whenever the output relay is energized

Optional 7-element LED signal strength display modules

Construction

Molded reinforced thermoplastic polyester housing, o-ring-sealed transparent

polycarbonate cover, molded acrylic lenses, and stainless steel hardware. Q45s

are designed to withstand 1200 psi washdown.

The base of cabled models has a 1/2-inch NPS integral internal conduit thread.

Connections

PVC-jacketed 2-wire (emitters) or 5-wire (all others) 2 m (6.5 ft) or 9 m (30 ft)

unterminated cables, or 3-pin (emitters) or 5-pin (all others) Mini-style quick-

disconnect (QD) fittings are available (“Q” - suffix models).

QD cables are ordered separately.

Application Notes

Transient suppression is recommended for contacts switching inductive loads.

Optional output timing modules are available.

Environmental Rating

NEMA 6P, IEC IP67

Operating Conditions

Temperature: −40 °C to +70 °C (−40 °F to +158 °F)

Maximum relative humidity: 90% at 50 °C (non-condensing)

Certifications

Q45VR2 Series Sensors

P/N 36339 Rev. H

www.bannerengineering.com - Tel: +1-763-544-3164

7