Specifications

Supply Voltage and Current

Universal voltage: 24 to 250 V ac, 50/60 Hz or 12 to 250 V dc (1.5 watts

maximum)

Supply Protection Circuitry

Protected against transient voltages

DC hookup is without regard to polarity.

Output Configuration

SPDT (Single-Pole, Double-Throw) electromechanical relay output. All models

except emitters.

Output Rating

Max. switching power (resistive load): 1250 VA, 150 W

Max. switching voltage (resistive load): 250 V ac, 125 V dc

Max. switching current (resistive load): 5 A @ 250 V ac, 5A @ 30 V dc derated

to 200 mA @ 125 V dc

Min. voltage and current: 5 V dc, 10 mA

Mechanical life of relay: 50,000,000 operations

Electrical life of relay at full resistive load: 100,000 operations

Output Protection Circuitry

Protected against false pulse on power-up

Output Response Time

15 milliseconds ON and OFF

Note: 100 millisecond delay on power-up. Relay is

de-energized during this time.

Required Overcurrent Protection

WARNING: Electrical connections must be made

by qualified personnel in accordance with local

and national electrical codes and regulations.

Overcurrent protection is required to be provided by end product application

per the supplied table.

Overcurrent protection may be provided with external fusing or via Current

Limiting, Class 2 Power Supply.

Supply wiring leads < 24 AWG shall not be spliced.

For additional product support, go to www.bannerengineering.com.

Supply Wiring (AWG)

Required Overcurrent Protection (Amps)

20

5.0

22

3.0

24

2.0

26

1.0

28

0.8

30

0.5

Repeatability

Opposed mode: 0.25 milliseconds

All other sensing modes: 0.5 milliseconds

Response time and repeatability specifications are independent of signal

strength

Adjustments

Light/Dark Operate select switch; and multi-turn Sensitivity control on top of

sensor beneath a transparent o-ring-sealed cover, allows precise sensitivity

setting (turn clockwise to increase gain). Optional logic and logic/display

modules have adjustable timing functions.

Indicators

top of the sensor.

Power (green) LED lights whenever 24 to 250 V ac, or 12 to 250 V dc power is

applied

light source, and pulses at a rate proportional to the strength of the received

light signal

Load (amber) LED lights whenever the output relay is energized

Optional 7-element LED signal strength display module

Construction

Molded reinforced thermoplastic polyester housing, o-ring-sealed transparent

designed to withstand 1200 psi washdown. The base of cabled models has a

1/2-inch NPS integral internal conduit thread.

Environmental Rating

NEMA 6P, IEC IP67

Connections

PVC-jacketed 2 m (6.5 ft) or 9 m (30 ft) unterminated cables, or Mini-style

quick-disconnect (QD) fittings are available (“Q”- suffix models). QD cables are

ordered separately.

Operating Conditions

Temperature: –25 °C to +55 °C (−13 °F to +131 °F)

90% at +50 °C maximum relative humidity (non-condensing)

Application Notes

Transient suppression is recommended for contacts switching inductive loads.

Optional output timing modules are available. See Output Timing Logic and

Signal Strength Display Modules on page 10 for more information.

Certifications

Q45VR3 Series Sensors

P/N 53997 Rev. D

www.bannerengineering.com - Tel: +1-763-544-3164

5