Current - peak inrush

2% of Range ± 20 mA

Effect of common mode

(typical)

100 V, 100 kHz, 20 A shunt < 15 mA

100 V, 100 kHz, 1 A shunt < 500 μA

100 V, 100 kHz, external shunt < 40 mV

Measurement accuracy -

frequency

Frequency (10 Hz to 20 kHz)

0.1% of Reading, with the peak of the signal extending 10% above and 10% below the DC level

Frequency (20 kHz to 1 MHz)

0.1% of Reading, with the peak of the signal extending 25% above and 25% below the DC level

Measurement accuracy - power

Watts accuracy

± 0.075% of Reading ± 0.075% of Range (PF=1, 45 - 850 Hz)

VA accuracy

VAR accuracy (typical)

VA ± VAerror 2 - W ± Werror 2 - VA

2 - W2

PF Accuracy

Measurement accuracy - harmonic

magnitude and phase (typical)

Voltage harmonics magnitude

(10 Hz to 480 kHz)

± 0.02% of Reading ± 0.1% of Range ± (0.04*F)% of Reading ± 0.05 V

Voltage harmonics phase

Current harmonics magnitude

(10 Hz to 480 kHz)

Current harmonics phase

Physical characteristics

Dimensions

mm

in

Height

102

4.0

Width

223

8.7

Depth

285

11.2

Weight

Kg

lb

Net (without lead set)

3.2

7.0

Temperature

C

F

Operating

0 °C to +40 °C

+32 °F to +102 °F

Nonoperating

-20 °C to +60 °C

-4 °F to +140 °F

Notes:

All stated accuracies are based upon a minimum of a 30-minute warm-up period.

If no frequency is measured, then the signal is considered DC for the purpose of accuracy.

F is the frequency measured in kHz. In the case of harmonics, F is the harmonic frequency.

Specifications are valid from 1 to 100% of range in low bandwidth and after a manual zero has been performed. Values below 1% are typical.

In high bandwidth, specifications are valid when the signal is greater than 10% of the range.

Harmonic specifications are always valid when the harmonic is greater than 2% of the range.

Measurement conditions during calibration: Instrument default settings unless otherwise stated, sine waves applied to V and I inputs, 30 min warm up, ambient temperature

23 °C ±5 °C.

Datasheet

www.tek.com 5