| 전자부품 데이터시트 검색엔진 |
|
TLE8110ED 데이터시트(PDF) 13 Page - Infineon Technologies AG |
|
|
|||||||||||||||||||||||||||||
TLE8110ED 데이터시트(HTML) 13 Page - Infineon Technologies AG |
|
13 / 74 page ![]() Data Sheet 13 Rev. 1.0 2018-03-07 TLE8110ED Smart Multichannel Low Side Switch with Parallel Control and SPI Interface Power Supply 5 Power Supply 5.1 Description Power Supply The TLE8110ED is supplied by analogue power supply line VDD which is used for the analogue functions of the device, such as the gate control of the power stages. The digital power supply line VCC is used to supply the digital part and offers the possibility to adapt the logic level of the serial output pins to lower logic levels. Figure 5 Block Diagram Supply and Reset Description Supply The Supply Voltage Pins are monitored during the power-on phase and under normal operating conditions for under voltage. If during Power-on the increasing supply voltage exceeds the Supply Power-on Switching Threshold, the internal Reset is released after an internal delay has expired. In case of under voltage, a device internal reset is performed. The Switching Threshold for this case is the Power-on Switching threshold minus the Switching Hysteresis. In case of under voltage on the analogue supply line VDD the outputs are turned off but the content of the registers and the functionality of the logic part is kept alive. In case of under voltage on the digital supply VCC line, a complete reset including the registers is performed. After returning back to normal supply voltage and an internal delay, the related functional blocks are turned on again. For more details, refer to the chapter “Reset”. The device internal under-voltage set will set the related bits in SDS (Short Diagnosis and Device Status) to allow the micro controller to detect this reset. For more information, refer to the chapter “Control of the Device”. Block_diag_Supply_Reset.vsd Input and Serial Inter- face Fault Detection Gate Control diagnosis register input register VDD VCC RST OUTx control register Logic control unit EN GND VCC Under Voltage Monitor VDD Under Voltage Monitor or or analogue control, diagnostic and protective functions |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |