Solid-state Timer

H3BA-N

19

■ Mounting

Surface Mounting

There is no particular restriction on surface mounting directions, but

be sure that the Timer is securely mounted horizontally.

P2CF Socket

When mounting the Timer vertically with the P2CF Socket, consider

the movable hooks and be sure that there is a 20-mm space on each

of the upper and lower parts of the Socket.

PL Socket

1.

Secure the Socket to the panel surface with screws and insert the

F-shaped hook into the sockets.

2.

Connect the Timer to the Socket and press the tip of each hook

by hand.

Panel Mounting

When the Y92F-30 Flush Mounting Adapter is used, insert the Timer

into the square hole from the front side of the panel and put on the

Flush Mounting Adapter from the rear side of the Timer. Press the

Flush Mounting Adapter so that the space between the Flush

Mounting Adapter and the panel is reduced as much as possible,

and secure the Flush Mounting Adapter with screws.

When using the US08, be sure to use 10.5-dia. max. multi-conductor

cable or 3-dia. max. insulated stranded wire for wiring.

When the Y92F-30, Y92F-70 or Y92F-71 Flush Mounting Adapter is

used, just insert the Timer into the square panel hole. If the panel

coating is too thick and the hooks do not click, spread open the

hooks appropriately to the left and right after inserting the Timer to

the hole.

■ Dismounting

Surface Mounting with P2CF

Panel Mounting

Loosen the screws of the Flush Mounting Adapter, spread open the

hooks, and remove the Mounting Adapter.

When the Y92F-30, Y92F-70, Y92F-71 Mounting Adapter is used,

press the hook inwards with the thumb and index finger of both

hands, and press the Timer towards the front side.

Duct

Hook

Panel

P2CF-08

Panel

Screw

Y92F-30

Spread open the hooks to the left and right.

Spread open the hooks to the left and right.

Panel

The illustration is an ex

ample with the Y92F-70.