www.ti.com

Connecting the USB2ANY

7

SNAU228 – January 2018

Submit Documentation Feedback

Copyright © 2018, Texas Instruments Incorporated

USB2ANY Interface Adapter

3

Connecting the USB2ANY

NOTE:

This section assumes you are using the USB2ANY in its gray plastic enclosure (as shown in

Figure 1). If the USB2ANY board has been removed from the enclosure, or the board came

without an enclosure, some interpretation and adjustments may need to be made in these

instructions.

The USB2ANY ships with two cables, one 10-pin and one 30-pin. Both cables are standard 0.050-in (1.25-

mm) pitch ribbon cables with IDC-type connectors. The connectors have a key to assure that they are

installed correctly.

Figure 4. 10-Pin Cable With Key

NOTE:

If you are using the USB2ANY board without its enclosure, the key must face away from the

PCB. Be sure to carefully align the male pins on the PCB with the cable connector.