5000 datasheet(15/42 Pages) TI

15 / 42 page

www.ti.com

Functional Description

SPMU365C – March 2014 – Revised October 2016

Submit Documentation Feedback

Hardware Description

2.1.6.3

Breadboard Connection

The breadboard adapter section of the board is a set of 98 holes on a 0.1 inch grid. Properly combined

with a pair of right angle headers, the entire Connected LaunchPad can be plugged directly into a

standard 300 mil (0.3 inch) wide solder-less breadboard. The right angle headers and breadboard are not

provided with this kit. Suggested part numbers are Samtec TSW-149-09-L-S-RE and TSW-149-08-L-S-RA

right angle pin headers and Twin industries TW-E40-1020 solder-less breadboard. Samtec TSW-149-09-

F-S-RE and TSW-149-09-F-S-RA may be substituted.

A detailed explanation of how to install the headers is available on the TI LaunchPad Wiki or at

http://users.ece.utexas.edu/~valvano/EE345L/Labs/Fall2011/LM3S1968soldering.pdf.

Nearly all microcontroller signals are made available at the breadboard adapter holes (X11). These signals

are grouped by function where possible. For example, all EPI signals are grouped on one side of the

connector. Many of the analog signals are grouped near VREF, and UART, SSI and I2C signals are

grouped by peripheral to make expansion and customization simpler.

Table 2-3 and Table 2-4 show the GPIO pin and signal muxing for the X11 breadboard adapter pads.

5000 데이터시트(PDF) 15 Page - Texas Instruments