STSPIN32F0A datasheet(30/41 Pages) STMICROELECTRONICS

30 / 41 page

Device description

STSPIN32F0A

30/41

DocID030766 Rev 2.0

6.7

Test mode

A dedicated pin TESTMODE is available to enter into the test mode.

In the application, the TESTMODE pin should be shorted to GND in order

not to enter the test mode inadvertently.

6.8

Operational amplifiers

The device integrates three rail-to-rail operational amplifiers suitable for signal conditioning,

in particular for current sensing.

The operational amplifiers provide a rail-to-rail output stage with fast recovery in the

saturation condition. The output stage saturation happens in linear applications when a

high amplitude input signal occurs and causes the output of the operational amplifier to

move outside its real capabilities.

Figure 14: Operational amplifiers

6.9

Comparator

A comparator is available to perform an overcurrent protection. The OC Comp pin can be

connected to the shunt resistor to monitor the load current, the internal OC threshold can

be set via MCU (PF6 and PF7 port, see Table 12: "OC threshold values").

When an OC event is triggered, the OC comparator output signals the OC event to the

PB12 and PA12 inputs of MCU (BKIN and ETR).

OP xP

OPxO

OP xN

OPAMP

To input

ADC

I NN

I NP

STSPIN32F0A 데이터시트(PDF) 30 Page - STMicroelectronics