| 전자부품 데이터시트 검색엔진 |
|
MCP47CVB02 데이터시트(PDF) 83 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
MCP47CVB02 데이터시트(HTML) 83 Page - Microchip Technology |
|
83 / 124 page ![]() 2018-2019 Microchip Technology Inc. DS20006089B-page 83 MCP47CXBXX 7.7 General Call Commands The MCP47CXBXX Acknowledges the general call address command (00h in the first byte). General call commands can be used to communicate to all devices on the I2C bus (at the same time) that understand the general call command. The meaning of the general call address is always specified in the second byte (see Figure 7-8). If the second byte has a ‘1’ in the LSb, the specification intends this to indicate a “Hardware General Call”. The MCP47CXBXX will ignore this byte and all following bytes (and A), until a Stop bit (P) is encountered. The MCP47CXBXX devices support the following I2C general call commands: • General Call Reset (06h) • General Call Wake-up (0Ah) The General Call Reset command format is specified by the I2C Specification. The general call wake-up command is a Microchip-defined format. The general call wake-up command will have all devices wake-up (that is, exit the Power-Down mode). The other two I2C specification command codes (04h and 00h) are not supported, and therefore, those commands are Not Acknowledged. If these 7-bit commands conflict with other I2C devices on the bus, the user will need two I2C buses to ensure that the devices are on the correct bus for their desired application functionality. FIGURE 7-8: General Call Formats. Note: Refer to the “NXP Specification”, #UM10204, Rev. 03 19, June 2007 docu- ment for more details on the general call specifications. The I2C specification does not allow ‘00000000’ (00h) in the second byte. S 0 A 0 x x 0 A General Call Address 7-Bit Command 0 0 0 0 0 0 0 x P 0 0 0 I2C ACK Bit(1) A P S x x I2C Start Bit GC Command I2C Stop Bit(2,3) Legend: x Note 1: The Acknowledge bit is generated by the MCP47CXBXX. 2: This command sequence does not need to terminate (using the Stop bit) and the general call com- mand can be repeated or another general call command can be sent. Only the first command will be accepted by the MCP47CXBXX. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |