UT110-UFD2

Overview

‧ Adopts advanced LDPC ECC engine with 3D NAND flash memory to improve reliability

‧ Global Wear Leveling

‧ Flash bad-block management

‧ Page Mapping

‧ Power Failure Management

‧ S.M.A.R.T.

‧ Hyper Cache Technology

‧ SMART Read Refresh™

Apacer’s UT110-UFD2 utilizes 3D NAND for higher capacity up to 64 GB and

provides more power efficiency than 2D NAND, with the aim of replacing a

conventional IDE hard disk drive.

UT110-UFD2 is a new generation USB flash drive compatible with the latest USB

specification – USB 3.1 Gen1 (SuperSpeed), with a maximum transfer rate of 5.0

Gbps. The connector is backward compatible with USB 2.0 and USB 1.1 interfaces.

With compliance with USB 3.1 specification, this USB drive can deliver up to 255

MB/s outstanding performance.

UT110-UFD2 is built with the highest durability and ruggedness with a special

Chip-On-Board (COB) packaging technology, which allows your precious files to be

safely stored and protected against dust, water and shock at all times.

Reliability wise, UT110-UFD2 is implemented with LDPC (Low Density Parity Check)

ECC engine to extend SSD endurance and increase data reliability while reading

raw data inside a flash chip. In addition, the drive comes with various

implementations including powerful hardware ECC engine, Wear Leveling , flash

block management, S.M.A.R.T., Page Mapping, etc. This product is well suited for

portable flash storage applications while operating at minimal power consumption.

Feature