cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna

•

Increase the separation between the equipment and receiver

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

•

Consult the dealer or an experienced radio/TV technician for help

In the case where an OEM seeks the lesser category of a Class A digital device for the final product, the following

statement must be included in the final product manual:

Note:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part

15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at his expense.

7.2

IC certification

This device contains license-exempt transmitter(s)/receiver(s) that comply with innovation, science and economic

development Canada’s license-exempt RSS(s). Operation is subjected to the following two conditions:

1.

this device may not cause interference

and

1.

this device must accept any interference, including interference that may cause undesired operations of the

device.

In addition, in accordance with RSS-102 clause 2.6, the RF exposure compliance distance of the BlueNRG-M2 is

set equal to 15 mm.

Modular approval

IC: 8976C-BNRGM2SA and 8976C-BNRGM2SP

In accordance with IC RSS-247, the BlueNRG-M2 is listed as a modular transmitter device.

This module is evaluated for stand-alone use only. Finished products incorporating multiple transmitters must

comply with collocation and RF exposure requirements in accordance with IC multi-transmitter product

procedures. Collocated transmitters operating in portable RF Exposure conditions (e.g. <20 cm from persons

including but not limited to body worn and hand held devices) may require separate approval.

7.2.1

Labeling instructions

When the BlueNRG-M2 is integrated into the final product, the OEM must ensure that the IC labeling

requirements are satisfied. A statement must be included on the exterior of the final product which indicates that

the product includes a certified module. The label should state the following (or similar wording that conveys the

same meaning):

Contains IC: 8976C-BNRGM2SA and 8976C-BNRGM2SP

or

this product contains IC: 8976C-BNRGM2SA and 8976C-BNRGM2SP

The OEM must include the following statements on the exterior of the final product unless the product is too small

(e.g. less than 4 x 4 inches).

7.3

CE certification

The BlueNRG-M2 module has been certified according to the following certification rules:

•

EN 300 328 V 2.1.1 (2016-11)(1)

•

ETSI EN 301 489-17 V3.1.1 (2017-02)(2)

•

ETSI EN 301 489-1 V2.1.1 (2017-02)(3)

•

EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011 + A2:2013(4)

•

EN 62311:2008

BlueNRG-M2

IC certification

DS13053 - Rev 2

page 16/30