© 2018 Integrated Device Technology, Inc.

24

September 11, 2018

F1240 Datasheet

Evaluation Kit Operation

Power Supply Setup

Set up a power supply in the voltage range of 4.75V to 5.25V with the power supply output disabled. The voltage can be applied via one of the

following connections (see Figure 47).



Directly to J8 connector



JP1 header connection (note the polarity of the GND pin on this connector)

Figure 47. Power Supply Connections

1

GND

Logic Control Setup

The Evaluation Board has the ability to control the F1240 in the Parallel or Serial Mode. The logic voltages can be applied through the J4

connector (see Figure 48). For both the parallel and serial mode see Table 14 for the connections.

Figure 48. Logic Connections

Pin 1

Pin 3

Pin 14