TMP47C101 datasheet(19/32 Pages) TOSHIBA

19 / 32 page

TOSHIBA CORPORATION

19/32

TMP47C101/201

In the interrupt processing, the program counter and

flags are automatically saved or restored but the accumulator

and other registers are not. If it is necessary to save or restore

them, it must be performed by program as shown in the fol-

lowing example. To perform the multi-interrupt, the saving

RAM area never be overlapped.

Example: To save and restore the accumulator and HL

XCH

HL, GSAV1;

RAM GSAV1

⇔ HL

XCH

A, GSAV1+2;

RAM GSAV1+2

⇔ Acc

Note. The lower 2 bits of GSAV1 should be “0’s”.

2.8.3 External Interrupt

When an external interrupt (INT1 or INT2) occurs, the interrupt

latch is set at the falling edge of the corresponding pin input

(INT1 or INT2). The external interrupt input is the hysteresis

type, each of high and low level time requires 2 or more

instruction cycles for a correct interrupt operation.

The INT1 interrupt cannot be disabled by the EIR, so that

it is always accepted in the interrupt enable state (EIF=”1”).

Therefore, INT1 is used for an interrupt with high priority such

as an emergency interrupt. When HOLD (INT1) pin is used for

the I/O port, the INT1 interrupt occurs at the falling edge of the

pin input, so that the interrupt return [RET1] instruction must

be stored at the interrupt entry address to perform dummy in-

terrupt processing.

2.9 Reset Function

When the RESET pin is held to the low level for three or more

instruction cycles when the power voltage is within the operat-

ing voltage range and the oscillation is stable, reset is per-

formed to initialize the internal states.

When the RESET pin input goes high, the reset is cleared

and program execution starts from address 000H. The RESET

pin is a hysteresis input with a pull-up resistor (220k typ.). Ex-

ternally attaching a capacitor and a diode implement a simpli-

fied power-on-reset operation

Figure 2-23. Simpliﬁed Power-On-Reset

Table 2-3. Initialization of Internal States by Reset Operation

TMP47C101 데이터시트(PDF) 19 Page - Toshiba Semiconductor

TMP47C101 데이터시트(HTML) 19 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

데이터시트 다운로드

링크 URL