MODEL: 10JFX

http://www.m-system.co.jp/

10JFX SPECIFICATIONS

ES-0872 Rev.10 Page 1/3

High-density Signal Conditioners 10-RACK

LINEARIZER

(field-programmable)

Functions & Features

• Accepting non-linear input and providing two linearized

outputs, proportional to the process variables

• Micro-processor based

• On-site calibration up to 16 points using a hand-held

programmer PU-2x

• Field-programmable input range

• Optional second channel output available at the front

terminals and at the Standard Rack connector

Typical Applications

• V-notch weir

• Gas analyzer

• Irregular-shaped tank level input for volume calculation

MODEL: 10JFX–[1][2][3]–R[4]

ORDERING INFORMATION

• Code number: 10JFX-[1][2][3]-R[4]

Specify a code from below for each [1] through [4].

(e.g. 10JFX-6A6-R/Q)

• Special input range (For codes U1, U2 & U3)

• Linearization data (max. 16 points)

Use Ordering Information Sheet (No. ESU-1669) to specify

linearization data when the I/O signals are nonlinear.

• Specify the specification for option code /Q

(e.g. /C01)

[1] INPUT

Current

A: 4 – 20 mA DC (Input resistance 250 Ω)

H: 10 – 50 mA DC (Input resistance 100 Ω)

Voltage

6: 1 – 5 V DC (Input resistance 1 MΩ min.)

U1: Range ±100 mV;

(Minimum span 3 mV, Input resistance 20 kΩ min.)

U2: Range ±1000 mV;

(Minimum span 30 mV, Input resistance 20 kΩ min.)

U3: Range ±10 V;

(Minimum span 0.3 V,Input resistance 1 MΩ min.)

[2] OUTPUT 1

Current

A: 4 – 20 mA DC (Load resistance 600 Ω max.)

Voltage

6: 1 – 5 V DC (Load resistance 500 Ω min.)

[3] OUTPUT 2

0: None

Voltage

6: 1 – 5 V DC (Load resistance 5000 Ω min.)

POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[4] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

RELATED PRODUCTS

• Programming Unit (model: PU-2x)

• PC configurator software (model: JXCON)

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

GENERAL SPECIFICATIONS

Construction: Rack-mounted; terminal access via screw

terminals at the front and via card-edge connector at the

rear; terminal cover provided

Connection

Input: M3.5 screw terminals (torque 0.8 N·m)

Output: Card-edge connector and M3.5 screw terminals

(torque 0.8 N·m)