9 Parameter Measurement Information

9.1 Solder Heat Shift

The materials used in the manufacture of the REF34-Q1 have differing coefficients of thermal expansion,

resulting in stress on the device die when the part is heated. Mechanical and thermal stress on the device die

can cause the output voltages to shift, degrading the initial accuracy specifications of the product. Reflow

soldering is a common cause of this error.

In order to illustrate this effect, a total of 32 devices were soldered on four printed circuit boards [16 devices on

each printed circuit board (PCB)] using lead-free solder paste and the paste manufacturer suggested reflow

profile. The reflow profile is as shown in Figure 9-1. The printed circuit board is comprised of FR4 material. The

board thickness is 1.65 mm and the area is 114 mm × 152 mm. All measurements were taken after baking at

150°C.

0

50

100

150

200

250

300

0

50

100

150

200

250

300

350

400

Time (seconds)

C01

Figure 9-1. Reflow Profile

The reference output voltage is measured before and after the reflow process; the typical shift is displayed in

Figure 9-2. Although all tested units exhibit very low shifts (< 0.01%), higher shifts are also possible depending

on the size, thickness, and material of the printed circuit board. An important note is that the histograms display

the typical shift for exposure to a single reflow profile. Exposure to multiple reflows, as is common on PCBs with

surface-mount components on both sides, causes additional shifts in the output bias voltage. If the PCB is

exposed to multiple reflows, the device must be soldered in the second pass to minimize its exposure to thermal

stress.

Solder Heat Shift (%)

0

10%

20%

30%

40%

50%

D017

- DBV Package

Solder Heat Shift (%)

0

10%

20%

30%

40%

50%

DGKs

- DGK Package

REF34-Q1

SBAS901C – JULY 2018 – REVISED OCTOBER 2020

www.ti.com

12

Submit Document Feedback

Copyright © 2020 Texas Instruments Incorporated

Product Folder Links: REF34-Q1